Аксессуары для экскаваторов Советы по ежедневному обслуживанию гусеничной плиты

Digger Track Shoe is one of the chassis parts of construction machinery, is the old construction machinery wearing parts. There are holes at both ends of the track plate, meshing with the driving wheel, and induction teeth in the middle, used for regulating the track, and to prevent the track from falling off when the excavator turns or tilts. On the side in contact with the ground, there is a strengthened anti-slip rib (referred to as the pattern), in order to improve the robustness of the digger track shoe and the adhesion between the track and the ground.

Often used in excavators, bulldozers, crawler cranes, pavers and other construction machinery. Excavator as construction machinery, daily maintenance is very important. In fact, as long as you spend a little time on proper maintenance, you can avoid big moves in the future. In order to save the maintenance funds and avoid the loss caused by the delay caused by the overhaul of the machine, the dig brother will share with you the daily maintenance of the PC300-5 excavator track plate.
Прежде всего, in the process of driving the excavator, it is necessary to avoid repeatedly walking on the inclined ground and suddenly turning for a long time, which will make the side of the chain and the side of the driving wheel and the guiding wheel meet, thus increasing the degree of wear. Straight travel and wide turns can effectively prevent wear and tear.

Moreover, if part of the CAT E312 excavator sprocket and the support wheel can not run under the state of continued use, it may lead to roller wear, but also may cause the wear of the chain joint. If a roller that does not work is found, it must be repaired immediately.

There is the carrier installation bolt, CAT E120 excavator track roller, track plate bolt, walking pipe bolt, sprocket installation bolt, because the excavation long time after work is easy to loose because of vibration, if continue to run in this case, may lead to the gap between the track plate and the bolt, and then lead to the digger track shoe cracks. Поэтому, regular inspection of bolts and nuts for firmness can reduce unnecessary maintenance costs.